1 Before Using the Machine
20
Before Using the Machine
1
2
Enter the Administrator ID with the numeric
keypad or the keyboard displayed, and
select [Enter].
When a passcode is required, select [Next]
and enter the system administrator’s
passcode, then select [Enter].
Note • The default user ID is "11111".
• The default passcode is "x-admin".
3
Select [Tools].
4
Select [Machine Clock/Timers].
5
Select [Power Saver/Energy Saver Timers],
and select [Change Settings].
6
Using [] and [], configure an energy saver
mode migration time, in 1 minute
increments.
From Last Operation to Low Power Mode
Set the time to move to the [Low Power
Mode] after the last operation.
Note • The default for [From Last Operation to Low Power Mode] is [1] minutes. The Low Power
Mode cannot be disabled.
To Next Page
Loading...
