Store to USB
177
Scan
4
Note • The behavior depends on settings. Ask your system administrator for more information.
• When a USB memory device is inserted into the USB memory slot during the Energy Saver
mode, the touch screen does not light. After exiting the Energy Saver mode by pressing the
<Energy Saver> button, insert the USB memory device again or select [Store to USB] on the
[Services Home] screen. For information on other ways to exit the Energy Saver mode, refer
to "Exiting the Energy Saver Mode" (P.40).
• The screen status will be one of the above even when a USB memory device in which only
encrypted data is stored is inserted or USB memory device in unsupported format is
inserted. In such case, a warning message appears during operation and the operation is
aborted.
• The screen status will be one of the above when a commercially available Memory Card
Reader is inserted into the USB memory slot of the machine. It is the same if no media is
inserted into the Memory Card Reader.
• If a commercially available Memory Card Reader is used and it is left inserted all the time,
the machine does not detect media even when they are inserted into the slot of the Memory
Card Reader.
• Screen display remains the same when the inserted USB memory device or Memory Card is
removed. Press the <Services Home> button or do anything else to change the screen
display before starting next operation.
When the [USB Device Detected] Screen Appears
1 Select [Store to USB].
2 Select a feature on the [Store to USB]
screen.
When the [Store to USB] Screen Appears
Select a feature on the [Store to USB]
screen.
To Next Page
Loading...
Need help?
General
