Fuji Xerox D110 User Manual

2 Product Overview
36
Product Overview
2
Switch the power off at the end of the day or when not using the machine for an
extended period of time.
Use also the Energy Saver feature to save power consumption while the machine is not
in use.
For information on the Energy Saver feature, refer to "Energy Saver Mode" (P.39).
1 Press the power switch to the [ | ] position to
switch the power on.
Note • The “Please wait...” message indicates that the
machine is warming up. The machine is not
available during warming up.
• If the machine is not powered on, check the
following:
• The power cord is plugged in.
• The main power is switched on.
• The ground fault interrupter is in the On ("l")
position.
Switching the Power Off
The following describes how to switch the power off.
1 Before switching the power off, make sure that the machine has completed all copy or
print jobs. Then, make sure that the <Data> indicator is not blinking.
Important • Do not switch the power off in the following situations. If the power is switched off, the
processing data may be erased.
• While data is being received
• While data is being sent (FTP/SMB/e-mail)
• While a job is being printed
• While a job is being copied
• While a job is being scanned
• While data is being imported from a computer
• When switching the power off, wait 5 seconds or more after outputs have been delivered.
2 Press the power switch to the [ ] position.
Important • Power off processing is performed internally on
the machine for a while after the power is
switched off. Therefore, do not switch the main
power off immediately after switching the
power off.
Note • When powering the machine on after it has
been switched off, wait 15 seconds or more
after the touch screen has gone dark.
Ground fault
interrupter
Test button

Fuji Xerox D110 Specifications

General

Brand	Fuji Xerox
Model	D110
Category	Printer
Language	English