EasyManua.ls Logo

Fuji Xerox DocuCentre-II 3005

Fuji Xerox DocuCentre-II 3005
615 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Error Code
477
Problem Solving
16
016-760
O [Cause] An error occurred during processing with Adobe PostScript
3 Kit (optional).
[Remedy] Take one of the following actions:
z
Set [Print Mode] to [Normal].
z
Expand PostScript memory.
For information about [Print Mode], refer to the print driver's online help.
For information about memory, refer to "Allocate Memory" (P.308).
016-761
O [Cause] An error occurred during image processing.
[Remedy] Set [Print Mode] to [Normal] and try again. If the problem
persists, set [Page Print Mode] to [On].
016-762
O [Cause] The specified print language is not installed on the
machine.
[Remedy] In [Specify Print Mode] under [Port Settings], specify
another print language.
016-763
O [Cause] Connection error to the POP server
[Remedy] Check if the IP address of the POP server is correctly set
on the machine.
016-764
O [Cause] Unable to connect to the SMTP server.
[Remedy] Contact the SMTP server administrator.
016-765
O [Cause] Unable to send the e-mail because the hard disk on the
SMTP server is full.
[Remedy] Contact the SMTP server administrator.
016-766
O [Cause] An error occurred on the SMTP server.
[Remedy] Contact the SMTP server administrator.
016-767
O [Cause] Unable to send the e-mail due to an incorrect address.
[Remedy] Check the address, and try again.
016-768
O [Cause] Unable to connect to the SMTP server due to the
machine's incorrect mail address.
[Remedy] Check the machine's mail address.
016-769
O [Cause] The SMTP server does not support confirmation of mail
distribution (DSN).
[Remedy] Send e-mail without setting confirmation of mail
distribution (DSN).
016-770
O [Cause] Direct Fax is disabled.
[Remedy] Check the system administrator if Direct Fax is available. If
it is available, contact our Customer Support Center.
016-774
O O O [Cause] Unable to process compression conversion due to
insufficient hard disk space.
[Remedy] Remove unnecessary data from the hard disk to increase
free disk space.
016-775
O O O [Cause] Unable to process image conversion due to insufficient
hard disk space.
[Remedy] Remove unnecessary data from the hard disk to increase
free disk space.
Error Code
Category
Cause and Remedy
CPFSMO
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.

Table of Contents

Other manuals for Fuji Xerox DocuCentre-II 3005

Related product manuals