14 Problem Solving
490
Problem Solving
14
124-706
O [Cause] The folding setting was cancelled.
[Remedy] Confirm the folding setting, and then execute the operation
again.
124-708
O [Cause] The output destination was changed to the Center Tray.
The probable causes are as follows:
1) Paper of a different size from the specified is loaded for
2 sided copying.
2) The Punching feature of the Finisher has malfunctioned.
[Remedy] For 1), check whether the specified size paper is loaded in
the tray.
For 2), confirm whether the error code 012-231, 012-232,
012-233, or 012-234 is displayed on the touch screen, and
contact our Customer Support Center.
[Remedy] Contact our Customer Support Center. Any trays other
than the defective output tray can be used.
124-709
O [Cause] The document exceeded the maximum number of pages
that can be stapled.
[Remedy] Reduce the number of pages, or cancel the stapling
setting, and then try printing again.
124-710
O [Cause] The output destination was changed from the mail box bin
because the mail box bin does not support the specified
paper size.
[Remedy] Specify the paper size that the mail box bin supports.
133-210
133-211
133-212
133-213
133-214
133-215
133-216
133-217
133-218
133-219
133-220
133-221
133-222
133-223
133-224
O [Cause] An error occurred during fax transmission.
[Remedy] Switch off the machine power, make sure that the touch
screen is blank, and then switch on the machine power. If
the error still is not resolved, contact our Customer
Support Center.
133-226
O [Cause] A country code not supported by the machine was
specified.
[Remedy] Contact our Customer Support Center.
133-280
133-281
133-282
133-283
O [Cause] An error occurred during fax transmission.
[Remedy] Switch off the machine power, make sure that the touch
screen is blank, and then switch on the machine power. If
the error still is not resolved, contact our Customer
Support Center.
Error Code
Category
Cause and Remedy
CPFSMO
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
Center. The contact number is printed on the label or card attached on the machine.
To Next Page
Loading...
Need help?
General
