Executing Calibration
87
Maintenance
3
The following describes how to perform calibration.
1 Press the <Log In/Out> button.
Note • You also can select [Calibration] on the
[Services Home] screen. Selecting
[Calibration] on the [Services Home]
screen shows the screen in step 6.
2 Enter the system administrator’s user ID with
the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next]
and enter the system administrator’s
passcode, and select [Enter].
Note • The default user ID is "11111".
• The default passcode is "x-admin".
3 Select [Tools] on the [Services Home]
screen.
Note • When the [Service Home] screen is not
displayed on the touch screen, press the
<Services Home> button.
4 Select [System Settings] > [Common
Service Settings] > [Image Quality
Adjustment].
5 Select [Calibration].
6 Select [Screen Type], [Paper Supply], and
[Target].
Note • The following describes calibration procedures using Copy Job, as an example.
123
456
789
0#
C
<Log In/Out> button
To Next Page
Loading...
