102 3 Printing
Sending DocuWorks Files Using Lpr Command
DocuWorks files can be sent directly to the printer using commands such as lpr. When
printing with commands, the following items are printed according to [XDW (DocuWorks)]
settings on the control panel.
Refer to
• “ [XDW (DocuWorks)]” (P. 145)“
Note
• When printing using the lpr command, use the lpr command to specify the number of copies. In such
cases, the [Quantity] setting on the control panel becomes invalid. If you do not specify the number of
copies using the lpr command, the printer assumes 1 set.
The following is an example of printing DocuWorks files from a computer using the lpr
command.
Note
• In the following examples, the bold characters are input characters.
• Spaces are indicated with U.
Example
At the command prompt, enter the command as follows.
Example: A command for printing “Report.xdw” when the printer’s IP address is
192.168.1.100.
• Quantity • Collated
• 2 Sided Printing • Layout
• Print Mode • Output Size
• Password • Output Color
C:\>lprU-SU192.168.1.100U-PUlpUReport.xdw
<Enter> key
To Next Page
Loading...
