188 5 Control Panel Settings
[Software Upgrade]
Note
• This item appears only when EP system is used. Contact our Customers Support Center or your dealer
for details.
• This item is not supported on the model available in China.
Transfer
ImageLog
- Sets transfer of image logs to the log server.
Log
Transfer
Set whether or not to enable the image log transfer feature.
• [Disabled] (default)
• [Enabled]
Logs To
Transfer
Sets automatic transfer of image logs.
• [Pause]
• [Per Job Basis]
• [Accumulate First] (default)
Note
• [Per Job Basis] is displayed when [Image Log Control] > [Assurance
Level] is set to [High].
Transfer
Timing
Sets the timing that image logs are transferred. Set [Disabled] or
[Enabled] for each of the transfer timings. Default is all [Enabled].
• [At end of the job]
• [At power On]
• [End of selections]
• [When max reached]
Assurance
Level
Sets the assurance level when data is transferred to the log server.
• [Low] (default)
•[High]
Note
• When [High] is set, data is transferred unconditionally. However,
during data transfer, printer performance might drop or printing may
be paused.
System Settings
Software Upgrade
Setting Description
Software Upgrade Allows to upgrade the firmware used in the printer to the latest version when
EP system using the Internet has been used.
Note
• EP system may not be available in some regions. Contact our Customers
Support Center or your dealer for its application.
Setting Description
To Next Page
Loading...
Need help?
General
