A.10 Installing the TC/SC Additional Fonts Kit 427
A.10 Installing the TC/SC Additional Fonts Kit
This section describes how to install the TC/SC Additional Fonts Kit on the printer.
Installation Procedure
1. Press the < > side of the printer's power
switch to turn off the power.
Note
• Make sure that there is no indication on the display,
and <Energy Saver> button is off.
2. Open the front cover.
3. Press the < > side of the printer's main
power switch to turn off the main power and
close the front cover.
Note
• The <Main Power> lamp goes out on the control
panel.
4. Unplug the power cord from the power
outlet and the printer.
TC/SC Additional Fonts Kit
To Next Page
Loading...
