4.2 Loading Paper 121
4.2 Loading Paper
This section explains how to load paper in the bypass tray or trays 1 to 4, and 6.
Note
• When the machine runs out of paper during printing, a message appears on the control panel. Add
paper according to the message instructions. Printing automatically resumes when paper is added.
Loading Paper in the Bypass Tray
Important
• Make sure to load paper when the power is on.
• Do not load paper of different types in the same tray.
• Do not remove paper from or add paper to the paper trays during printing. Doing so can cause paper
jams.
• Do not place any objects other than paper on the bypass tray. Do not push down the tray or apply an
excessive force to the tray.
1. Lower the bypass tray.
Extend the tray as required. The extension
tray can extend two levels.
2. Load the paper with the print side facing
down.
Important
• Do not load paper of different types and sizes into the
tray. Doing so can cause paper jams.
Important
• If the paper will not feed into the machine when
printing thick paper, curl the leading edge of the paper
as shown in the illustration and then load it into the
tray. However, paper that is overly curled or creased
will cause paper jams.
Note
• A different loading method is used when loading
envelopes, labels, and long size paper. Refer to
“ Bypass Tray Feed Orientations for Envelopes”
(P. 122) and “3.3 Printing on Custom Size or Long-size
Paper” (P. 76).
To Next Page
Loading...
Need help?
General
