A.5 Installing Extension System Memory 407
Procedure for Installing Extension System Memory
This section describes how to install extension system memory on the printer.
Note
• The printer has two memory card slots. Slot 1 already has the standard Memory 1024 MB installed. Use
Slot 2 to install extension system memory.
• Memory capacity can be expanded to a maximum of 2 GB by installing a Memory 1024 MB card in Slot
2 and replacing the memory card in Slot 1 with a Memory 1 GB card.
1. Press the < > side of the printer's power
switch to turn off the power.
Note
• Make sure that the display is blank and the <Energy
Saver> button does not light up.
2. Open the front cover.
3. Press the < > side of the printer's main
power switch to turn off the main power and
close the front cover.
Note
• The <Main Power> lamp goes out on the control
panel.
4. Unplug the power cord from the power
outlet and the printer.
Extension System Memory
To Next Page
Loading...
