72 3 Printing
3.2 Printing on Envelopes
This section describes how to print on envelopes.
Note
• Envelopes cannot be printed using Tray 1 (Standard), Tray 2 to 4, and Tray 6 (optional).
Loading Envelopes
Only printing on the address side of the envelope is supported.
The following envelope sizes can be used with this printer.
Important
• For best print quality, do not use envelopes that:
• are curled or twisted.
• are stuck together or damaged.
• have windows, holes, perforations, cutouts, or embossments.
• use tie strings, metal clamps, or metal folding bars.
• have postage stamps attached.
• have any exposed adhesive when the flaps are closed.
• have deckle edges or creased corners.
• are wrinkled, rough or are glued.
• have adhesive flaps open.
Envelopes can be printed using the bypass tray only.
Note
• For more information on how to load paper in the bypass tray, refer to “Loading Paper in the Bypass
Tray” (P. 121).
1. With the printing side (example:address
side) face down, close the flaps of the
envelopes and position them so they feed
from the flap side.
Refer to
• For information on how to load envelopes in the
bypass tray, refer to “ Bypass Tray Feed Orientations
for Envelopes” (P. 122).
2. Adjust the paper guides to the size of the
envelopes.
• Envelope C4 (229 x 324 mm)
• Envelope C5 (162 x 229 mm)
• Monarch Envelope (3.9 x 7.5")
• No.10 Envelope (4.1 x 9.5")
• DL Envelope (110 x 220 mm)
To Next Page
Loading...
Need help?
General
