322 7 Maintenance
Replacing the 200K Maintenance Kit
The following message appears on the printer’s control panel when the 200K Maintenance
kit is near or reaches the end of its service life.
Important
• Do not touch the roller part of the 2nd BTR Unit.
Replacing the 2nd BTR Unit
1. Switch off the power.
Important
• While the printer is in the Energy Saver mode, press
the <Energy Saver> button to exit the mode, and then
switch off the power.
Refer to
• For information on how to switch off the power and the
main power, refer to “2.2 Switching On/Off the Power”
(P. 57).
2. Open Tray 5 (1), and then while lifting up
the release lever (2) gently open the upper
left cover A (3).
3. Push the lever in the direction of an arrow.
4. Take out the 2nd BTR Unit.
Message Action
Ready Replace
Trans. Roll
The 2nd BTR Unit and Paper Feed Rolls need to
be replaced soon. Use the 200K Maintenance Kit
to replace them.
To Next Page
Loading...
Need help?
General
