Fuji Xerox DocuPrint C5005 d User Manual

5.2 Common Menus Setting 157
[Port 9100]
Network/Port
Port 9100
Port 9100
Port Status
Port 9100
Print Mode
Port 9100
PJL
Port 9100
Connect Time-Out
Port 9100
Port Number
Port 9100
TBCP Filter
Setting Description
Port Status Sets whether to enable or disable the Port9100 port at printer start-up.
• [Enabled] (default)
•[Disabled]
Important
• If the printer runs out of memory when the port is enabled, the port is
sometimes automatically disabled. If this happens, either disable unused
ports, or change the memory allocation under [Allocate Memory].
Print Mode Sets the method of processing data (language emulation).
• [Auto] (default)
After receiving data from a computer, the printer automatically detects its
language emulation and processes the data accordingly. (See *1 on P. 214.)
• [PS] [ESCP] [HP-GL/2] [PCL] [TIFF] [KS] [KSSM] [KS5895]
After receiving data from a computer, the printer processes the data with the
selected print language.
•[HexDump]
Allows you to view data received from a computer by printing it in ASCII code
(hexadecimal format). (See *3 on P. 214.)
PJL Sets whether to enable or disable PJL commands that are sent from the
computer.
PJL commands control print jobs, and are required to print jobs using the print
driver. Use of PJL commands allows you to specify the language emulation for
the next job while another language emulation is being processed by the
printer. (See *5 on P. 214.)
• [Enabled] (default)
•[Disabled]
Connect Time-Out Sets the time after which data reception is canceled if data is not received.
Specify the value from 2 to 65535 seconds in 1-second increments. (See *2 on
P. 214.)
• [60 Seconds] (default)
Port Number Sets the port number from 1 to 65535. (See *2 on P. 214.)
• [9100] (default)
Note
• Set only unique port numbers.

Fuji Xerox DocuPrint C5005 d Specifications

General

Brand	Fuji Xerox
Model	DocuPrint C5005 d
Category	Printer
Language	English