158 5 Control Panel Settings
[UPnP]
[WSD]
Note
• WSD stands for Web Services on Devices.
TBCP Filter Sets whether to enable or disable the TBCP filter during processing of
PostScript data.
• [Disabled] (default)
• [Enabled]
Network/Port
UPnP
UPnP
Port Status
UPnP
Port Number
Setting Description
Port Status Sets whether to enable or disable the UPnP port at printer start-up.
• [Enabled]
• [Disabled] (default)
Important
• If the printer runs out of memory when the port is enabled, the port is
sometimes automatically disabled. If this happens, either disable unused
ports, or change the memory allocation under [Allocate Memory].
Port Number Sets the port number from 1 to 65535. (See *2 on P. 214.)
• [80] (default)
Note
• Set only unique port numbers. Note, however, that InternetServices/IPP/
SOAP/UPnP/WSD (See *6 on P. 214) ports and Internet services that use
HTTP protocol can share the same port number.
Network/Port
WSD
WSD
Port Status
WSD
Port Number
Setting Description
Port Status Sets whether to enable or disable the WSD port at printer start-up.
• [Enabled] (default)
•[Disabled]
Important
• If the printer runs out of memory when the port is enabled, the port is
sometimes automatically disabled. If this happens, either disable unused
ports, or change the memory allocation under [Allocate Memory].
Setting Description
To Next Page
Loading...
