7.1 Replacing Consumables 311
Emptying the Punch Waste Container
When the finisher is installed and the hole punch waste container R4 becomes full, a
message appears on the display. When the message appears, empty the hole punch waste
container as instructed.
Important
• Empty the hole punch waste container when the machine is on.
• Make sure to discard all paper chads when emptying the hole punch waste container. Not doing so will
cause the container to fill up before the message telling you to empty the container appears again, and
this can cause machine malfunction.
Disposal procedure (for Finisher-B1)
1. Make sure that the machine is not
operating, lift the finisher transport cover F,
and then open the front transport door G of
the finisher.
2. Pull out the hole punch waste container.
3. Empty the container.
4. Insert the emptied hole punch waste
container into the finisher until it stops.
To Next Page
Loading...
Need help?
General
