A.7 Installing the Feature Enhance Kit 413
A.7 Installing the Feature Enhance Kit
This section following describes how to install the Feature Enhance Kit (optional).
Note
•
The HDD Extension Kit
(optional) and a extension system memory (optional) are required when installing
the Feature Enhance Kit (optional).
Installation Procedure
1. Press the < > side of the printer's power
switch to turn off the power.
Note
• Make sure that there is no indication on the display,
and <Energy Saver> button is off.
2. Open the front cover.
3. Press the < > side of the printer's main
power switch to turn off the main power and
close the front cover.
Note
• The <Main Power> lamp goes out on the control
panel.
4. Unplug the power cord from the power
outlet and the printer.
Feature Enhance Kit ROM
To Next Page
Loading...
