60 2 Basic Operation
2.3 Circuit Breaker
The printer is provided with a circuit breaker. In the event of a current leakage, the circuit
breaker will automatically cut off the power circuit to prevent any leakage of fire from
occurring. Check that the circuit breaker works properly at least once a month. Be sure to
establish a ground for the machine. Without a proper ground, the circuit breaker may be
disabled, causing a risk of electric shock.
If you have any problems with the circuit breaker, contact our Customer Support Center or
your dealer.
The following describes how to check the circuit breaker.
1. Press the < > side of the printer’s power
switch to turn off the power.
Note
• Make sure that the display is blank and the <Energy
Saver> button does not light up.
2. Open the front cover.
3. Press the < > side of the printer’s main
power switch to turn off the main power.
Note
• The <Main Power> lamp goes out on the control
panel.
4. Press the <RESET> button.
Note
• Confirm that the button will stay pressed even after the
pushing force is released.
<RESET>
button
To Next Page
Loading...
