5.2 Common Menus Setting 159
[SOAP]
[ThinPrint]
Note
• This item appears only when HDD Extension Kit (optional) is installed.
• To use ThinPrint
®
feature, contact our Customers Support Center or your dealer for details.
Port Number Sets the port number from 1 to 65535. (See *2 on P. 214.)
• [80] (default)
Note
• Set only unique port numbers. Note, however, that InternetServices/IPP/
SOAP/UPnP/WSD ports and Internet services that use HTTP protocol can
share the same port number.
Network/Port
SOAP
SOAP
Port Status
SOAP
Port Number
Setting Description
Port Status Sets whether to enable or disable the SOAP port at printer start-up.
• [Enabled] (default)
•[Disabled]
Important
• If the printer runs out of memory when the port is enabled, the port is
sometimes automatically disabled. If this happens, either disable unused
ports, or change the memory allocation under [Allocate Memory].
Port Number Sets the port number from 1 to 65535. (See *2 on P. 214.)
• [80] (default)
Note
• Set only unique port numbers. Note, however, that InternetServices/IPP/
SOAP/UPnP/WSD (See *6 on P. 214) ports and Internet services that use
HTTP protocol can share the same port number.
Network/Port
ThinPrint
ThinPrint
Port Status
ThinPrint
Port Number
ThinPrint
SSL/TLS
Setting Description
To Next Page
Loading...
