4.2 Loading Paper 127
3. Gently slide the tray back in as far as it will
go.
Important
• When inserting the tray, push it gently. Forcibly
pushing the tray in may cause machine malfunction.
Changing the Paper Size for Tray 6
1. Pull out Tray 6 until it stops.
2. Remove any paper loaded in the tray.
3. Open the end guide (1) and unscrew the
screw (2). And then remove the guide from
the tray.
4. Insert the small protrusions at the bottom of
the guide into the holes corresponding to
the paper size (1). Insert the protrusion on
the tray into a hole corresponding to the
paper size on the top of the guide, and
tighten up the screw (2).
To Next Page
Loading...
Need help?
General
