Safety Notes 17
The printer is provided with a circuit
breaker. In the event of a current leakage,
the circuit breaker will automatically cut off
the power circuit to prevent any leakage of
fire from occurring. The circuit breaker is
normally ON (indicated as < | >). Check that
the circuit breaker works properly at least
once a month. If you have any problems
with the circuit breaker, contact our
Customer Support Center or your dealer.
The following describes how to check the
circuit breaker.
1. Press the < > side of the printer’s
power switch to turn off the power.
2. Make sure that the display is blank
and the <Energy Saver> button does
not light up.
3. Open the front cover.
4. Press the < > side of the printer’s
main power switch to turn off the main
power.
5. Press the <RESET> button. Confirm
that the button will be depressed even
after the pushing force is released.
6. Press the <TEST> button lightly with a
sharp edge such as a pen tip. The
depressed <RESET> button will stick
out again.
7. Press the <RESET> button back to
the depressed position.
8. Press the < | > side of the printer’s
main power switch to turn on the main
power and then close the front cover.
Do not attempt to remove a paper jammed
deeply inside the product, particularly a
paper wrapped around a Fusing Unit or a
heat roller. Otherwise, it may cause injuries
or burns. Switch off the product promptly
and contact your local Fuji Xerox
representative.
Never touch the paper output area of the
finisher during operation. It may cause
injuries.
Be careful in removing jammed staples.
Ventilate well during extended operation or
mass printing. It may affect the office air
environment due to odor such as ozone in
a poorly ventilated room.
Provide proper ventilation to ensure the
comfortable and safe environment.
<RESET>
button
<TEST>button
To Next Page
Loading...
Need help?
General
