6.7 Error Messages and Error Codes 261
Insufficient funds
Insert valid card
Print job has been paused due to insufficient funds. Use a valid card to continue.
Note
• Pressing the <Information> button will display detailed information on the control
panel.
Job has paused
Use Smart Card
The print job has been paused. Use a smart card to continue.
Note
• Pressing the <Information> button will display detailed information on the control
panel.
Load Tray N
<size and orientation> <type>
(N: 1 to 4, 6)
The tray N that contains the paper specified for printing (the size or type) is out of
paper.
Load paper into the applicable tray. This message also appears when none of the
printer's trays are loaded with the paper specified for printing (the size or type). In this
case, change the size, orientation, or type of one of the printer's trays so it matches
the settings shown on the display.
If the message persists after the correct paper is loaded, the machine may not
recognize the paper size correctly. Make sure the position of the paper guides.
Note
• Pressing the <Information> button will display detailed information on the control
panel.
Refer to
• “ Loading paper into Trays 1 through 4” (P. 124)
• “ Loading Paper into Tray 6 (HCF B1)” (P. 126)
Lower Finisher Exit
Cover H
The Lower Finisher Exit Cover H is open.
Close the cover tightly.
Lower Finisher
Transport Cover F
The Lower Finisher Transport Cover F is open.
Close the cover F tightly.
No such paper type
Print from N
(N: Tray 1, Tray 2, Tray 3, Tray 4
or Tray 5)
No paper type specified by the print driver is loaded on the paper tray.
Load paper indicated by the message, into the paper tray to print.
Open Door G and
reinsert Hole
Punch Waste
Container R4
The Hole Punch Waste Container is full of punch waste.
Empty the Hole Punch Waste Container.
Refer to
• “ Emptying the Punch Waste Container” (P. 311)
Open Finisher Front
Door and add
staples to Staple
Cartridge R1
No staples are in the Staple Cartridge R1.
Open the finisher’s front door and add the new staples to the Staple Cartridge R1.
Refer to
• “ Replacing Staple Cartridge” (P. 305)
Open Finisher Front
Door and reinsert
Hole Punch Waste
Container R4
The Hole Punch Waste Container is full of punch waste. Take out the hole punch
waste container to discard all paper chads.
Refer to
• “ Replacement Procedure (for Finisher-B1)” (P. 305)
• “ Replacement Procedure (for Finisher-C1 with Booklet Maker)” (P. 307)
Open Finisher Front
Door and reinsert
Staple Cartridge R1
The Staple Cartridge R1 is not set properly. Open the Finisher Front Door to set the
cartridge properly.
Refer to
• “ Emptying the Punch Waste Container” (P. 311)
Message Symptom/Cause/Remedy
To Next Page
Loading...
