308 7 Maintenance
4. Pinch both sides of the empty staple case
with your fingers (1), and remove the staple
case from the cartridge (2).
5. Insert the front side of the new staple case
into the staple cartridge (1), and then push
the rear side into the cartridge (2).
6. Push the staple cartridge into the finisher
until it clicks into place.
7. Close the front door.
Note
• If the front door is not completely closed, a message
will appear and the machine remain paused.
Replacement Procedure (for Finisher-C1 with Booklet Maker)
When the message Staple Cartridge R2 / R3 is displayed on the display, follow the
instruction below to replace the staple cartridge with a new one.
1. Make sure that the machine is not
operating, and open the front door.
To Next Page
Loading...
Need help?
General
