1.2 Connecting a cable 31
7. Select [Install from a list or specific location
(Advanced)], and then click [Next].
8. Select [Search for the best driver in these
locations].
9. Check the [Search removable media
(floppy, CD-ROM)] check box, and then
click [Next].
10. Click [Finish].
Installation is complete.
Note
• Message [Ready to print IP Address failed] may be displayed on the control panel. To erase this
message, set to [STATIC] in [Network/Port] > [TCP/IP Settings] > [IPv4 Settings] > [Get IP Address] to
specify IP address (Example: 192.168.1.100) or [Disabled] for each port other than the USB port in
[Network/Port].
Refer to
• For setting method of IP address, refer to “Setting the Network Environment” (P. 36).
• For setting each port, refer to “Enabling Ports” (P. 40).
To Next Page
Loading...
Need help?
General
