Fuji Xerox DocuPrint CP315 dw

7 Troubleshooting
149
Problem Action
The printout has ghosting. 1 Identify the type of ghosting.
If the type of ghosting is positive ghost, proceed to step 2a.
If the type of ghosting is negative ghost, proceed to step 2b.
If the type of ghosting is not identified, contact Fuji Xerox local representative
office or an authorized dealer.
2a Adjust the transfer bias.
a Press the <Menu> button.
b Press the or button to select [Administrator Menu], and then press
the button.
c Press the or button to select [Maintenance Mode], and then press
the button.
d Press the or button to select [Adjust TransferBelt], and then press
the button.
e Select [K Offset] or [YMC Offset], and then decrease the value.
If the problem persists, proceed to step 3.
2b Adjust the transfer bias.
a Press the <Menu> button.
b Press the or button to select [Administrator Menu], and then press
the button.
c Press the or button to select [Maintenance Mode], and then press
the button.
d Press the or button to select [Adjust TransferBelt], and then press
the button.
e Select [K Offset] or [YMC Offset], and then increase the value.
If the problem persists, proceed to step 3.
3 Make sure that the correct print media is being used.
Refer
• For details, see "Supported Print Media (P.64)."
If the problem persists, proceed to step 4.
4 Replace the drum cartridges and print a Demo Page for verification.
Refer
• For details, see "Replacing the Drum Cartridges (P.103)" and "[Demo
Page] (P.44)."
If the problem persists, contact Fuji Xerox local representative office or an
authorized dealer.
Positive ghost Negative ghost