User Guide
148
Mottle
Ghosting
Problem Action
The printout is mottled. 1 Make sure that the correct print media is being used.
• For details, see "Supported Print Media (P.64)."
If the problem persists, proceed to step 2.
2 Raise the transfer unit voltage.
• For details, see "[Adjust 2nd BTR] (P.57)."
3 Replace the drum cartridges and print a Demo Page for verification.
• For details, see "Replacing the Drum Cartridges (P.103)" and "[Demo
Page] (P.44)."
If the problem persists, contact Fuji Xerox local representative office or an
authorized dealer.
To Next Page
Loading...
