Fuji Xerox DocuPrint CP315 dw

User Guide
46
▌
[Administrator Menu] > [PCL Settings] >
[Hex Dump]
Specifies whether to help to isolate the source of a print job problem. With this setting enabled, all data sent to
the printer is printed in hexadecimal and character representation. Control codes are not executed.
▌
[Administrator Menu] > [PCL Settings] >
[Draft Mode]
Specifies whether to save toner when printing. The print quality is reduced when printing in this mode.
▌
[Administrator Menu] > [PCL Settings] >
[LineTermination]
Adds the line termination commands.
▌
[Administrator Menu] > [PCL Settings] >
[Output Color]
Specifies the color mode.
▌
[Administrator Menu] > [PCL Settings] >
[Ignore Form Feed]
Specifies whether to ignore blank pages that only contain form feed control codes.
▌
[Administrator Menu] >
[PDF Settings]
Use this menu to change printer settings that only affect PDF files.
▌
[Administrator Menu] > [PDF Settings] >
[Quantity]
Specifies the number of copies to print.
▌
[Administrator Menu] > [PDF Settings] >
[2-Sided Print]
Specifies whether to print on both sides of a sheet of paper. For a two-sided printing, you can specify the
printout to be bound by the long edge or short edge.
▌
[Administrator Menu] > [PDF Settings] >
[Print Mode]
Specifies the print mode.
[Off]
The line termination command is not added.
CR=CR, LF=LF, FF=FF
[Add-LF]
The LF command is added.
CR=CR-LF, LF=LF, FF=FF
[Add-CR]
The CR command is added.
CR=CR, LF=CR-LF, FF=CR-FF
[CR-XX]
The CR and LF commands are added.
CR=CR-LF, LF=CR-LF, FF=CR-FF
[Normal]
For documents with normal sized characters.
[High Quality]
For documents with small characters or thin lines, or documents printed using
a dot-matrix printer.
[High Speed]
Prints with the higher speed than the [Normal] mode, but the quality is less.