Fujitsu Airstage J-II - Model Selection Procedure

MODEL SELECTION PROCEDURE1.
Selection of indoor units
See 2-2.MODEL LINE UP (INDOOR UNIT) and
3-1. SELECTION PROCEDURE OF INDOOR UNIT AND
OUTDOOR UNIT
See 2-3.MODEL LINE UP (OPTIONAL PARTS)
See 2-3.MODEL LINE UP (OPTIONAL PARTS)
See 2-1.MODEL LINE UP (OUTDOOR UNIT) and
3-1. SELECTION PROCEDURE OF INDOOR UNIT AND
OUTDOOR UNIT
Selection of required optional parts
Cassette grille for all Cassette type ●
EV kit for AS ●

E04-14
Selection of controller units
System Controller ●
System Controller Lite ●
Touch Panel Controller ●
Central Remote Controller ●
Group Remote Controller ●
Wired Remote Controller ●
Simple Remote Controller (with operation mode) ●
Simple Remote Controller (without operation mode) ●
Wireless Remote Controller ●
Selection of adaptor / convertor
Network Convertor ●
Network Convertor for L ●
ON
W
ORKS
®
BACnet ●
®
Gateway
Signal Amplifier ●
External Switch Controller ●
Selection of branch kit
Separation Tube ●
Header ●
END
Selection of other optional parts
Flange (square) ●
Flange (round) ●
Long-Life Filter ●
IR Receiver Unit ●
Remote Sensor Unit ●
Drain Pump Unit ●
Air Outlet Shutter Plate ●
Panel Spacer ●
Wide Panel ●
Insulation Kit for High humidity ●
Fresh air intake kit ●
Auto louver grille kit ●
Selection of outdoor unit
See 2-3.MODEL LINE UP (OPTIONAL PARTS)
See 2-3.MODEL LINE UP (OPTIONAL PARTS)
See 2-3.MODEL LINE UP (OPTIONAL PARTS)
- (02 - 01) -
MODEL SELECTION MODEL SELECTION