WIRING DESIGN4.
ELECTRICAL WIRING4-1.
PRECAUTION FOR ELECTRICAL WIRING
Regulation on wire diameter and selecting circuit braker size differ from locality.
Install in accordance with regional standard.
WARNING
Do not turn on the power until all installation work is complete. ●
Always install a circuit breaker in the power supply cable for the unit. Failure to use a circuit ●
breaker could result in electrical shock or fire.
Before starting work, check that power is not being supplied to the unit. ●
Connect the connection cable firmly to the terminal board. Imperfect installation may cause a fire. ●
Always fasten the outside covering of the connection cable with the cord clamp. (If the insulator is ●
chafed, electric leakage may occur.)
Always connect the ground wire. ●
Never install a condenser for improving the power factor. (It will not improve the power factor and ●
the condenser will become abnormally hot.)
- (06 - 44) -
SYSTEM
DESIGN
SYSTEM
DESIGN
To Next Page
Loading...
