Fujitsu Airstage J-II - Model Selection and Capacity Calculation; Outdoor Unit; Selection Procedure of Indoor Unit and Outdoor Unit

MODEL SELECTION AND CAPACITY CALCULATION3.
SELECTION PROCEDURE OF INDOOR UNIT AND 3-1.
OUTDOOR UNIT
Please select indoor units and outdoor unit and make the capacity of each indoor unit be larger
than cooling and heating load.
Conrm the design indoor and outdoor temperature condition
Calculate heat load of each room
Select indoor unit to match the heat load for each room preliminarily
Change to a larger
capacity of indoor unit
Estimated capacity of indoor unit
≥ Heat load
Calculate the estimated capacity of each indoor units (Refer to 3-2)
Find indoor unit capacity at design temperature ●
Calculate the estimated capacity ●
Compensation coefcient of pipe length (COOLING)
Compensation coefcient of pipe length and frosting/defrosting (HEATING)
Calculate the total capacity of indoor units at
the rated condition ●
the design temperature condition ●
A

YES
NO
- (02 - 06) -
MODEL SELECTION MODEL SELECTION