REMOTE SENSOR UNIT2-14.
MODEL : UTY-XSZX
FEATURES
New amenity space can be offered by installing the Remote sensor.
ELECTRICAL WIRING
Remove the screws from the remote sensor, and remove the cover. ●
Connect the cable to the remote sensor as shown below. ●
Ensure that the wires do not contact each other. ●
Remote sensor
To indoor unit
Cable
INSTALLATION
When the cable is attached to the wall
z
Remove the material covering the wiring penetration (thin material) in the cover of the sensor ●
unit with a pair of cutters. The cable passes through this hole.
Now attach the remote sensor on the wall using the screws. ●
Screw (big)
Unit : mm
Mounting hole dimensions
- (05 - 93) -
CONTROL
SYSTEM
CONTROL
SYSTEM
To Next Page
Loading...
