MOUNTING POSITION1-3.
OUTDOOR UNIT
For the air conditioner to operate satisfactorily, install it as outlines in installation manual.
Outdoor unit mounting position
z
A position where satisfies the mounting space described in “ ●
chapter
3. 3 Installation space".
A position where the unit can be installed horizontally. ●
A position with enough space for performing pipe work, service and maintenance. ●
A position where satisfies the pipe limitations of height and length between the outdoor units to be connected ●
Outdoor unit mounting limitation
z
A position that is not exposed to strong or seasonal winds. ●
A position where the blown air does not accumulate. ●
A position where there are no obstructions to the air near to the inlet and outlet. ●
A position not exposed to radiation from other heat sources. ●
A position where the discharge air will not affect animals or plants. ●
A position where the noise and hot air will not disturb the neighbour. ●
A position with strong installation fixings, which can sufficiently bear the product weight. ●
A position that does not transmit noise or vibration. ●
A position where drain water discharge is not a problem. ●
A position where snow does not accumulate. ●
A position not easily affected by electrical noise. ●
A position out of reach of children. ●
A position where there is no danger of the generation, influx or accumulation of flammable gas. ●
A position that does not have a special environment such as large amounts of oil, vapor or sulfide gas. ●
Precaution for outdoor unit mounting position
z
Mount the outdoor unit in a position where its tilt is 3 degrees or less. ●
When mounting units on each floor or multiple units, secure enough outlet space to prevent a short circuit effect. ●
In cold or snowy regions, make sure that the mount is high enough and install a snow protection hood. ●
Drain water is discharged from the outdoor unit during operation, so make sure that this drain water is possible to ●
flow.
Use material such as vibration-resistant rubber to prevent the transmission of vibration to the floor. ●
Securely fix the unit when it may be in a position exposed to strong winds. ●
- (06 - 11) -
SYSTEM
DESIGN
SYSTEM
DESIGN
To Next Page
Loading...
