Fujitsu Airstage J-II - Page 374

START/STOP button1
Pressed to start and stop operation.
Set Temperature button2
Selects the setting temperature.(18-30°C[COOL], 10-30°C[HEAT])
Operation mode button 3

2
Selects the operating mode (AUTO

1, COOL , DRY ,
FAN

3, HEAT

4).
Fan control button4
Selects the fan speed (AUTO , LOW , MED , HIGH ).
Vertical air ow direction and swing button5
Press for two seconds to change the swing mode
Horizontal air ow direction and swing button6
Press for two seconds to change the swing mode.
Built-in thermo sensor7
Detect room temperature.
Timer mode (CLOCK ADJUST) button8
Selects the timer mode (OFF TIMER, ON TIMER, WEEKLY TIMER)
Set the current time.
Day (DAY OFF) button9
Temporarily cancels of one day timer.
Set back button10
Pressed select the set back timer.
Set time button11
Pressed to select the set back timer.
Delete button12
The schedule of a weekly timer is deleted.
Set button13
Sets the date, hour, minute and on-off time.
Economy button / Thermo sensor button14
Filter button15
Operation lamp16
Lights during operation and when the timer is on.
Timer and clock indicator17
Operation mode indicator18
Fan speed indicator19
Operation lock indicator20
Temperature indicator21
Displayed temperature is set temperature.
Defrost indicator22
Indicates during the oil recovery and defrosting operation.
Vertical swing indicator 23
Horizontal swing indicator 24
Economy indicator25
Thermo sensor indicator 26
Filter indicator27
FUNCTIONS

Display panel

1 : "AUTO " is not available for a heat pump model unless it is set up as an administrative indoor
unit.

2 : Indoor unit can be set to administrative indoor unit by pressing "MODE" button for 5 seconds or
more.

3 : "FAN " is not available for a heat pump model.

4 : "HEAT " is not available for a cooling only model.
7
Display
13
12
11
10
2
8
9
16
15
14
1
3
5
4
6
18
17
1920 21
2223 242527 26
- (05 - 70) -
CONTROL SYSTEM CONTROL SYSTEM