Fujitsu Airstage J-II - Page 405

ELECTRICAL WIRING

L N
POWER
X1 X2
TRANSMISSION
Y1 Y2 Y3 J1
REMOTE INDOOR UNIT
REMOTE CONTROLLER LINE
J2 J3
1Ø 50/60 Hz
208-240 V
SWITCH
FUSE (3 A)
Transmission Line to VRF System Transmission Line to VRF System
Wired Remote Controller
Indoor Unit
Power Supply
NETWORK CONVERTOR
RC line to
indoor unit
RC line
to RC
Transmission line
Power
supply
NOTES:
Do not bind the power cable and remote controller cable to avoid an erroneous operation. ●
Use shield cable for transmission line and remote controller line. The shield metal should be grounded. ●
Use ground wire to ground the network convertor. ●
- (05 - 101) -
CONTROL SYSTEM CONTROL SYSTEM