Important
: Network Convertor will not operate if,
VRF network system address (Outdoor and Indoor units address) allocation ●
information are not registered to Network Convertor.
XIF data information and VRF network system address allocation information must ●
not be same.
Binding and Commissioning is not executed. (During binding, read out the Network ●
Convertor Neuron ID by pushing BMS service switch [SW 2] on the main PC board
of Network Convertor.)
If the ID number registered to the Network Convertor is not same as the ID number ●
which is included in the XIF of Network Convertor.
- (05 - 114) -
CONTROL
SYSTEM
CONTROL
SYSTEM
To Next Page
Loading...
