INDOOR UNIT SETTING
Please refer to the correct SW position for 2. Function Setting.
Refrigerant circuit address setting
Indoor unit address setting
Remote controller address setting
Function setting
Set the Rotary SW REF AD x10 & x1
See the detail for "1-2. Address setting"
Set the Rotary SW IU AD x10 & x1
See the detail for "1-2. Address setting"
Set the Rotary SW RC AD
See the detail for "1-2. Address setting"
<step 1>
<step 2>
<step 3>
<step 4>
RB UNIT SETTING
Please refer to the correct SW position for 2. Function Setting.
(This function is available VR-II series)
Refrigerant circuit address setting
RB unit address setting
Set the Rotary SW REF AD x10 & x1
See the detail for "1-2. Address setting"
Set the Rotary SW RB AD x10 & x1
See the detail for "1-2. Address setting"
<step 1>
<step 2>
REMOTE CONTROLLER SETTING
In case of Wired remote controller, Simple remote controller.
Dual remote control setting
Set the SW 2 of DIP Switch 1
See the detail for "2. Function setting"
Other than above unit , Please refer the 2. Function setting and installation manual.
¾
- (07-02) -
FUNCTION
SETTING
FUNCTION
SETTING
To Next Page
Loading...
