Fujitsu Airstage J-II - Page 530

KINDS OF ADDRESS AND SETTING RANGE

UNIT SETTING
SETTING
RANGE
TYPE OF SWITCH REMARKS
RB unit
O
Refrigerant
circuit address
00 ~ 99
n
Manual address setting
Setting
example
01
Arbitrary numbers can be
set in range of 00-99
n
Automatic address setting
Set this switch to 00 at factory setting.
See the setting method 1-5-3.
P RB unit address 00 ~ 63
n
Manual address setting
Setting
example
12
Arbitrary numbers can be
set in range of 00-63
n
Automatic address setting
Set this switch to 00 at factory setting.
See the setting method 1-5-3.
Touch panel
controller
G
Controller /
Convertor
address
00 ~ 15
*1
See the setting method 2-11
Network
convertor
H
Setting
example
01
See the setting method 2-14
Refrigerant
circuit address
00 ~ 99
Group remote
controller
I
Group remote
controller
address
00 ~ 03
See the setting method 2-10
Wired, simple
remote
controller (3-
wire type)
J
Dual remote
control
ON/OFF SW 2 of DIP Switch 1
See the setting method 2-9
Signal
amplier
K
Signal amplier
address
1 ~ 8
n
Manual address setting
See the setting method 2-15
n
Automatic address setting
Set to 1 at factory setting.
See the setting method 1-5-1
Network
convertor for
L
ON
W
ORKS
®
M
Controller /
Convertor
address
00 ~ 15
*1
See the setting method 2-14
Central
remote
controller
N
See the setting method 2-12
Wired remote
controller (2-
wire type)
F
Remote
controller
address
1 ~ 32
*2
n
Manual address setting
See the setting method 2-13-1
0 ~ 15
n
Automatic address setting
Dual remote
control
ON/OFF
See the setting method 2-13-2
*Set up after conrming the details of each unit.
*1: The sum total of the Touch panel controller, Central remote controller, Network convertor for Group remote controller
and Network convertor for L
ON
W
ORKS
®
is a maximum of 16.
Note: Address of the Touch panel controller, Central remote controller, Network convertor for Group remote
controller and Network convertor for L
ON
W
ORKS
® must not be same.
*2: The address can be set from 1 to 32. However, do not set the same number as that for the remote-controller
address of an indoor unit connected using the same remote-control cable.
Please set "Remote controller address" of Wired remote controller (2-wire type) in Manual address setting only. It is
not necessary to set in Automatic address setting.
REF AD
x10
REF AD
x1
RB AD
x10
RB AD
x1
SW 110 SW 111
(10 digit) (1 digit)
- (07-04) -
FUNCTION SETTING FUNCTION SETTING