Fujitsu Airstage J-II - Page 562

PREPARATION

3) Turn on the power to the indoor unit.
By turning on the power indoor units initializes EEV, so make sure the piping air-tight test and ●
vacuuming have been conducted before turning on the power.
Also check again to make sure no wiring mistakes were made before turning on the power. ●
Indoor
units
Indoor
units
Breaker ON
SWITCHING SELECTION OF ADDRESS SETTING MODE

4) When the [Function Setting] on the “Maintenance” screen is touched, the “Installer
Password Verification” screen is displayed.
Enter the Installer Password, and touch the [OK]. “Function Setting” screen is displayed.
Previous
Page
Back
Next
Page
Page 2/ 3 Maintenance
Test Run
R.C. Address
Setting
Function Setting
I.U. Address
Setting
[002–01]
[00]
[00]
Address
Function No.
Setting No.
Function Setting
Back Setting
Address setting mode initial display
- (07-36) -
FUNCTION SETTING FUNCTION SETTING