Fujitsu Airstage J-II - Page 622

SWITCHING SELECTION OF FUNCTION SETTING MODE

(2) Press and hold the “MANUAL/AUTO”
button for 3 seconds.
Pi Pi Pi
MANUAL
AUTO
MANUAL AUTO
IR RECEIVER UNIT
(3) Press and hold the “FAN” and the “ SET
TEMP.
p
” buttons. Whilst holding these
2 buttons, press the "RESET" button.
SET TEMP. ( )
RESET
FAN
Function setting
mode display
The position of the “MANUAL/AUTO” button varies depending on the model. ●
Refer to the operation manual for the position that is included with the unit.
The error will be displayed by continuously pressing the "MANUAL/AUTO" for 10 sec or more. In this case ●
release the button or turn off the power.
An explanation of the displayed information as shown below. ●
SELECTION AND CONFIRMATION OF CUSTOM CODE

(4) Press the “ SET TEMP.
p
” or “ SET
TEMP.
q
” buttons to select the custom
code that matches the setting with the
indoor unit.By selecting the appropriate
custom code, the communication between
the indoor unit and the wireless RC
become possible.
CUSTOM CODE
(
- -
-
)
The initial setting is " "
(5) Press the “TIMER MODE" button to send
the code to the indoor unit.
Pi Pi
Correct code:
Wrong code:
No Response
- (07-96) -
FUNCTION SETTING FUNCTION SETTING