Fujitsu Airstage J-II - Page 642

FUNCTION SETTING

5) Pressing the "+" or "-" button, select a remote controller address (select the indoor unit you
want to operate). Then press the "ENTER" button.
Ex.) When remote controller address “01” is selected
Remote controller address
6) Pressing the "+" or "-" button, to select the function number. Then press the "ENTER"
button.
Function number
7) Pressing the "+" or "-" button, to select the setting number. Then press the "ENTER"
button.
Ex.) Function number : 30,
Setting number : 01
Setting number
GOODERROR
When the data was not set up on the indoor ●
unit (-- is displayed.)
Set up the data again. ●
When the data was normally set up on the ●
indoor unit.
8) Pressing the "ENTER" button to return to the address selection screen. If setting has been
completed, pressing the "MENU" button to return to the Menu 2 item selection screen.
FUNCTION DETAILS

Refer to 2-8. FUNCTION DETAILS.
- (07-116) -
FUNCTION SETTING FUNCTION SETTING