Fujitsu Airstage J-II - Page 650

DIP SWITCH 1 SETTING

SW1 setting prohibited
z
(
u
...Factory setting)
SW1
u
OFF Fixed at OFF
ON Setting prohibited
SW2 setting
z
Dual remote controller setting
●
Set the remote controller SW2 according to the following table.
(
u
...Factory setting)
Number
of remote
controller
Master unit Slave unit
SW2 SW2
u
1 (Normal) OFF -
2 (Dual) OFF ON
SW3 setting prohibited
z
(
u
...Factory setting)
SW3
u
OFF Fixed at OFF
ON Setting prohibited
SW4 setting prohibited
z
(
u
...Factory setting)
SW4
u
OFF Fixed at OFF
ON Setting prohibited
SW5 setting prohibited
z
(
u
...Factory setting)
SW5
u
OFF Fixed at OFF
ON Setting prohibited
SW6 setting
z
Memory backup setting (Wired remote controller only)
●
Set to ON to use batteries for the memory backup.
If batteries are not used, all of settings stored in memory will be delete if there is a power
failure.
(
u
...Factory setting)
SW6 Memory backup
u
OFF Invalidity
ON Validity
Never turn it ON in the case of simple remote controller.
1 2 31 2 3
1 2 3
Indoor unit
Remote controller cable
When ground wire
is necessary
Master unit Slave unit
Remote controller
- (07-124) -
FUNCTION SETTING FUNCTION SETTING