CENTRAL REMOTE CONTROLLER2-13.
ADDRESS SETTING
Display the Installer Setting screen and Press the [
●
] button and move the cursor to
"Central Controller Address Setting".
Press the [
●
] button.
Central remote controller address setting
Press the [UP] button or [Down] button.
●
Set the Address value.
●
The Address value can be set from 00 to 15.
When the [
●
] button is pressed, setting is complete.
Note:
Address No. can be set between "00" and "15". (Up to maximum 16 Central Remote ●
Controller can be installed to 1 system).
When installing two or more Central Remote Controller, set up so that Address No. ●
does not overlap.
Please refer to the OPERATING MANUAL of Central Remote Controller for details. ●
Please keep Address No. of Central Remote Controller from overlapping the controller ●
(Touch Panel Controller, Network Convertor for LonWorks, and Network Convertor for
Group Remote Controller) connected to the same VRF Network system
- (07-128) -
FUNCTION
SETTING
FUNCTION
SETTING
To Next Page
Loading...
