When function setting is "Forced stop" mode
z
In the case of "Edge" input
●
Connector Input signal Command
Ch1 of
CNA01 or CNA02
OFF → ON Forced stop
ON → OFF Normal
Ch1 input of
CNA01 or
CNA02
Remote
Controller
Indoor unit
Operation
On
On On On
Off
Stop
Command
Forced stop
Normal
In the case of "Pulse" input
●
Connector Input signal Command
CNA01 or CNA02
Ch1 OFF → ON Forced stop
Ch2 OFF → ON Normal
Operation
On
On
The width of pulse must be longer than 200msec.
Off
Off
Stop
CNA01
or
CNA02
Ch1 input
Ch2 input
Remote
Controller
Indoor unit
On On On
Command
Forced stop
Normal
NOTE :
When the forced stop is triggered, indoor unit stops and Operation/Stop operation by a ●
remote controller is restricted.
- (08 - 13) -
EXTERNAL INPUT
& OUTPUT
EXTERNAL INPUT
& OUTPUT
To Next Page
Loading...
