1. Model selection and capacity calculation
1-1. Model selection procedure
Selection of indoor units
Refer to following information:
•
“Indoor units” of "Model lineup" in Chapter 3. OUT-
DOOR UNITS on page 03-1
• "Indoor unit and outdoor unit selection procedure" on
page 02-2
↓
Selection of required optional parts
Refer to "Optional parts" in Chapter 1. GENERAL INFOR-
MATION on page 01-5.
↓
Selection of outdoor units
Refer to following information:
• “Outdoor units” of "Model lineup" in Chapter 3. OUT-
DOOR UNITS on page 03-1
• "Indoor unit and outdoor unit selection procedure" on
page 02-2
↓
Selection of controllers
Refer to “Controllers” of "Optional parts" in Chapter 1.
GENERAL INFORMATION on page 01-5.
↓
Selection of adapter and convertor
Refer to “Adapter/Convertor/Maintenance tool” of "Option-
al parts" in Chapter 1. GENERAL INFORMATION on
page 01-5.
↓
Selection of branch kit
Refer to following informations:
• “Outdoor unit branch kit” of "Optional parts" in Chap-
ter 1. GENERAL INFORMATION on page 01-5
• “Separation tube” of "Optional parts" in Chapter 1.
GENERAL INFORMATION on page 01-5
• “Header” of "Optional parts" in Chapter 1. GENERAL
INFORMATION on page 01-5
↓
Selection of other optional parts
Refer to “Others” of "Optional parts" in Chapter 1. GEN-
ERAL INFORMATION on page 01-5
.
↓
End
1-1. Model selection procedure - (02-1) - 1. Model selection and capacity calculation
MODEL
SELECTION
MODEL
SELECTION
To Next Page
Loading...
