Fujitsu AIRSTAGE J-IIIL - Page 675

e Write value input
The value input here is set at the write value field of the unit selected in
d
.This input value be-
comes the setting change value of the item selected in
c
.
NOTES:
•
For the set value of each function setting, refer to "Function details" on page 07-96, or the
Installation manual of the indoor unit or the outdoor unit.
• When clearing the write value, click the Set button with the field blank after selecting the tar-
get unit.
f Read button
Acquires the value of the item selected in
c
from the unit selected in
d
, and displays it at the
read value field in
d
. After the acquirement of the value is completed, subsequent processing
can be canceled by clicking the button again.
g Write button
Performs setting of the value input at the write value field of
d
. for the unit selected in
d
.
Thereafter, the setting contents result is displayed at the read value field of
d
for check use.
After the setting is completed, subsequent processing can be canceled by clicking the button
again.
h Progress bar
Displays the processing progress of
f
or
g
.
i Close button
Closes this screen (Remote Setting screen). However, when read/write processing for unit was
performed, confirmation dialog box opens to confirm whether to save the data to a CSV file.
NOTES:
•
When both remote setting of the outdoor unit and the setting from the push button on the
PCB of the outdoor unit are performed, the setting performed later will be valid.
• When the remote setting of the outdoor unit and the setting from the push button on the PCB
of the outdoor unit are performed at the same time, the remote setting will be invalid. Check
that the push button is not used before starting the remote setting.
2-3. Setting by service tool (UTY-ASGXZ1) - (07-75) - 2. Function settings
FUNCTION SETTINGS FUNCTION SETTINGS