Fujitsu ETERNUS DX100 S3 - Rear; Figure 1.2 Front View of a 3.5 Type Controller Enclosure; Figure 1.3 Rear View of a Controller Enclosure (When Only One Controller Is Installed)

■
3.5" Type
Figure 1.2 Front View of a 3.5" Type Controller Enclosure
1
3 3
2
1. Operation panel
2. 3.5" drive
3. Flange cover
1.1.2 Rear
This section provides the names of the components in the rear of a controller enclosure.
■
When Only One Controller Is Installed
Figure 1.3 Rear View of a Controller Enclosure (When Only One Controller Is Installed)
1
2
34
1.
Controller (CM#0)
2. Cover
Remove this when installing an additional controller (optional).
3. Power supply unit (PSU#0)
4. Power supply unit (PSU#1)
Chapter 1 Component Names and LED Names
1.1 Controller Enclosures
15
FUJITSU Storage ETERNUS DX100 S4/DX200 S4, ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems Operation Guide (Basic)
Copyright 2017 FUJITSU LIMITED
P3AM-7662-09ENZ0