Fujitsu ETERNUS DX100 S3 - Installing Additional Drive Enclosures; Installable Drive Enclosures; Drive Enclosure Handling Instructions

5.2 Installing Additional Drive Enclosures
Drive enclosures can be installed while the ETERNUS DX is running without affecting the system.
This section explains how to install drive enclosures in the ETERNUS DX.
Do Not
•
Do not uninstall or move a drive enclosure that is already installed.
Contact your sales representative or maintenance engineer if a drive enclosure
needs to be uninstalled or moved.
Do
•
When installing the ETERNUS DX, secure the rack to the floor to prevent the rack
from moving out of place or from toppling over. For details on the rack installation
requirements, refer to "Site Planning Guide".
5.2.1 Installable Drive Enclosures
For installable drive enclosures, refer to "Product List".
5.2.2 Drive Enclosure Handling Instructions
■
About Condensation
Do
•
When moving a drive enclosure from a cold place, such as an unconditioned store
house in winter, to a warmer place such as an air-conditioned room, the severe
temperature change may result in condensation forming.
To avoid this, allow the packed drive enclosure sufficient time in the warmer place
(one hour for each 15°C of temperature difference) to adapt to the new tempera-
ture.
Chapter 5
Component Expansion/Function Enhancement
5.2 Installing Additional Drive Enclosures
79
FUJITSU Storage ETERNUS DX100 S4/DX200 S4, ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems Operation Guide (Basic)
Copyright 2017 FUJITSU LIMITED
P3AM-7662-09ENZ0