5.2.3 Additional Drive Enclosure Installation Procedure
This section explains how to install additional drive enclosures in the ETERNUS DX.
•
If components are installed in a way other as described in this section, damage
and/or device failure or electrical shock may occur.
•
Do not install the drive enclosure in the rack with cables, such as power cords, con-
nected.
•
Do not knock the other devices installed in the rack when installing drive enclo-
sures.
When connecting the mini SAS HD cable between enclosures, check the direction of the connector (the tab
must be pointed downward) and firmly insert all the way in.
To disconnect the mini SAS HD cables between enclosures, hold the tab and then pull out the connector.
Chapter 5
Component Expansion/Function Enhancement
5.2 Installing Additional Drive Enclosures
81
FUJITSU Storage ETERNUS DX100 S4/DX200 S4, ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems Operation Guide (Basic)
Copyright 2017 FUJITSU LIMITED
P3AM-7662-09ENZ0
To Next Page
Loading...
