Fujitsu ETERNUS DX100 S3 - Figure 1.19 Controller (ETERNUS DX100 S3;DX200 S3)

Two types of host interfaces, which are shown in Figure 1.19, can be installed in the controller.
Table 1.5 shows the status and meanings of each LED.
Figure 1.19 Controller (ETERNUS DX100 S3/DX200 S3)
•
Pattern 1
1 2 3 4
7
11 9
12 10
6
5
14
15
14
15
13
13
8
1313
•
Pattern 2
1
56
14 15
14 1513 13 13 13
78 9
23
10 11 12
4
1.
PWC port
This port is used to connect a power synchronization unit with an RS232C cable.
2. DI (OUT) port
This port is used to connect a controller enclosure to a drive enclosure with a mini SAS HD cable between
enclosures.
3. RMT (LAN) port
This port is used for connecting a LAN cable and used for the remote support function. This port uses an
RJ-45 connector.
4. MNT (LAN) port
This port is used for connecting a LAN cable and used for operation management. This port uses an RJ-45
connector.
5. Host interface (CA#0)
Install host interfaces. For details, refer to "■ Host Interfaces" (page 29).
6. Host interface (CA#1)
Install host interfaces. For details, refer to "■ Host Interfaces" (page 29).
7. IDENTIFY/SCU READY LED
8. CA#0 FAULT LED
9. DI (OUT) LINK/FAULT LED
10. READY/FAULT LED
Chapter 1 Component Names and LED Names
1.1 Controller Enclosures
28
FUJITSU Storage ETERNUS DX100 S4/DX200 S4, ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems Operation Guide (Basic)
Copyright 2017 FUJITSU LIMITED
P3AM-7662-09ENZ0