Fujitsu ETERNUS DX100 S3 - Components (Front); Figure 1.40 Operation Panel (High-Density Drive Enclosure); Table 1.11 Status and Meanings of each LED (Operation Panel (High-Density Drive Enclosure))

1.3.3 Components (Front)
This section describes the operation panel and the Disk Activity Panel (DAP) in the front of the high-density
drive enclosure.
■
Operation Panel
An operation panel has a DE-ID display and LEDs.
Figure 1.40 shows the operation panel. Table 1.11 shows the status and meanings of each LED.
Figure 1.40 Operation Panel (High-density Drive Enclosure)
2
1
3
4
1.
DE-ID
The DE-ID (drive enclosure number) of the drive enclosure is displayed.
2. IDENTIFY LED
3. FAULT LED
4. POWER LED
The LEDs turn on or blink to indicate the statuses that are listed below.
Table 1.11 Status and Meanings of Each LED (Operation Panel (High-density Drive Enclosure))
LED name
LED status Meaning
IDENTIFY
(blinks blue)
The installation location of the drive enclosure is identified ac-
cording to the instruction that is issued from ETERNUS Web GUI or
ETERNUS CLI.
FAULT
(amber)
The drive enclosure is in error status.
POWER
(green)
DC power is supplied to the drive enclosure.
Chapter 1 Component Names and LED Names
1.3 High-density Drive Enclosure
42
FUJITSU Storage ETERNUS DX100 S4/DX200 S4, ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems Operation Guide (Basic)
Copyright 2017 FUJITSU LIMITED
P3AM-7662-09ENZ0